All of the Accurshear's control buttons - Stroke control, Stroke counter, and Backgauge selects - are located on a front console. To make it readily accessible, the console is mounted to a swing arm pendant from the side of the Accurshear.

There are three Mode Selects for various shearing applications:
Jog Mode, Manual Mode, and Auto Cycle.

Primary Backgauge Controls

1. On/Off Machine Buttons


2. Mode Selector Switch; Jog, Manual, Auto


3. Stroke Length Control


4. LED readout in .001" increments


5. Stroke counter, Hour meter, Inch/metric conversion


6. Backgauge Calibration


7. 99 pre-select backgauge settings


8. Go-to-position Key


9. Backgauge motor - OFF/On
   Backgauge retract - On/Hold

The backgauge control features a keypad display, LED readout, and ninety-nine pre-select programmable positions. Under normal use, the operator keys in the desired backgauge setting, presses the "Go To" key, and the backstop bar moves to position. The Accurshear may also be programmed for single-step, or sequential shearing.

To accommodate high accuracy, the backstop bar actually moves slightly beyond the desired position and then comes forward to eliminate any clearance between the lead screws and nuts. The shear operator may also choose the backgauge retract feature via the key switch. This retracts the stop bar once the holddowns clamp the material just prior to the shear cycle to avoid material wedging between the shear knives and stop bar.