85° - 90° Forming Punches & Dies

85° punch and die combinations are used for air bending techniques. To produce sharp, close-tolerance bends in light gauges, 90° punch and die combinations must be specified.

Click to view 85° - 90° Forming Punches & Dies catalog page.

30° Forming Punches & Dies

30° dies are used for forming acute angle bends in 22 gauge through to 3/16".

Click to view 30° Forming Punches & Dies catalog page.

Gooseneck Punches & Dies

All Gooseneck punches and die combinations are machined at 85° for air bend techniques unless otherwise specified. These punches are used for forming right angle bends, channels, or other special bends where a straight 90° punch would interfere. GN #7, 8 and 9 punches are cut back further beyond the centerline for a greater flange.

Click to view Gooseneck Punches & Dies catalog page.

Allowable Return Flanges
for Gooseneck Punches

Click to view Allowable Return Flanges catalog page.

Offset Dies

Offset dies are sold in sets. General purpose offset dies form two 90° bends in one stroke.

Click to view Offset Dies catalog page.

Flattening Dies

Flattening dies are sold in sets. They are used to complete hems, or to close a previously formed angle to a given degree.

Click to view Offset Dies catalog page.

Hemming Dies

These combinations are used for hemming on a two-stroke operation.

• HM-1 is used to hem 18 gauge or lighter.
• HM-2 is capable of both air-bending and hemming light gauge material.
• HM-3 is for hemming material heavier than 18 gauge.
• HM-4 can be customized to suit individual applications.

Ram Adaptors

Ram adaptors may be necessary to fill up die space if ram adjustment is insufficient, or to suit conditions for box forming. They are available in a variety of heights, have safety tangs, and are manufactured from 4150 material.